Product Condition: New
PLEASE DO NOT USE KLARNA "PAY AFTER DELIVERY" FOR THIS ITEM.
KIT ORDERS MUST BE PAID IN FULL BEFORE DISPATCH.
Loa 2.26m (7’ – 6”)
Beam 1.19m (3’ – 11”)
Draft 0.127m (0’ – 5”)
Dry Weight 22.5kgs (50lbs)
The Winchelsea 2.2 is available as a kit and as DIY plans. It is a little smaller than the Winchelsea 8 and the planks can be cut from a standard sheet of 2.44m x 1.22m plywood - no scarfing required. It is different from its larger sister as it does not have a long keel which is replaced by a flat keel plank onto which a length of timber and a skeg are fitted. The open edge of the stem is capped with thin strips of wood that are carefully bent round to join at the keel.
The flat keel plank makes for an easier build but it is still built in the same way - over a mould. However, it could be built using stitch & tape if you don’t mind the stitch holes. If you’re painting your hull inside and out, this is not a problem but, if you want to varnish your hull then don’t use it.
Delivery Included for UK Mainland Only - Highlands & Islands Extra
Please contact us if you need any further information.
This kit is available as a plywood only or full kit as below.
Full Plywood Epoxy Kit - £780.00
Contains everything you need to build the hull to a stage where you only need to add paint/ varnish and a set of oars or a motor. All the plywood parts including the mould and centre support plus the cable ties and epoxy materials to put it all together. The wood for the seats and trim is also supplied
Plywood Only Kit - £485
All the marine plywood planks, transom, centre build frame support, mould, breast hook, quarter knees seat tops all pre-cut ready for assembly and full construction plans. Add the epoxy and this will build the hull ready for the timber trim and paint/varnish
The Winchelsea 2.2 is also available as a Part Built or Fully built boat including oars with options to add an electric motor package and/or sail rig.